295/30R22 Tire Size in Inches

Diameter, width, sidewall and the closest equivalent sizes, computed from the size code.

295/30R22
29.0" tall × 11.6" wide
On a 22-inch wheel · roughly 29.0x11.6R22 in flotation sizing
MeasurementInchesMillimetres
Overall diameter28.97736
Section width11.61295
Sidewall height3.4888.5
Wheel diameter22559
Circumference91.02312
Revolutions per mile696 (433 per km)

What 295/30R22 means

295 is the section width in millimetres (11.6 in). 30 is the aspect ratio: the sidewall is 30% as tall as the tire is wide, which works out to 88.5 mm or 3.5 in. R22 is a radial tire for a 22-inch wheel.

Overall diameter is the wheel plus two sidewalls: 22 + 2 × 3.48 = 29.0 inches. These are the nominal dimensions every maker builds to; a real 295/30R22 can measure a few tenths of an inch differently by model and inflation.

Closest equivalent sizes

Common sizes within the usual 3% of 295/30R22's overall diameter. Confirm load index, speed rating and rim width before swapping.

SizeDiameterWidthChangeSpeedometer at 60
235/70R16 new wheels 29.0 in 9.3 in -0.1% really 60.0 mph
235/65R17 new wheels 29.0 in 9.3 in +0.2% really 60.1 mph
255/40R21 new wheels 29.0 in 10.0 in +0.2% really 60.1 mph
255/45R20 new wheels 29.0 in 10.0 in +0.2% really 60.1 mph
255/50R19 new wheels 29.0 in 10.0 in +0.2% really 60.1 mph
255/55R18 new wheels 29.0 in 10.0 in +0.3% really 60.2 mph

Speedometer if you switch to 235/70R16

Your speedometer stays calibrated for 295/30R22. With a shorter tire you travel slower than it shows.

Speedometer readsTrue speed
30 mph30.0 mph
45 mph45.0 mph
55 mph55.0 mph
65 mph65.0 mph
75 mph75.0 mph
Compare 295/30R22 with any size →

Shop 295/30R22 tires

Check the load index and speed rating on your door-jamb placard before you buy, especially for LT tires used for towing.

See 295/30R22 tires on Amazon →

As an Amazon Associate we earn from qualifying purchases.

Frequently Asked Questions

A 295/30R22 tire is 29.0 inches (736 mm) tall overall. That is the 22-inch wheel plus two sidewalls of 3.5 inches each (30% of the 295 mm section width). Expect a real tire to measure within a few tenths of an inch of this, depending on the model and inflation.

The section width is 295 mm, or 11.6 inches, measured sidewall to sidewall on the recommended rim width. The tread itself is narrower than that. In flotation sizing, 295/30R22 is roughly a 29.0x11.6R22.

235/70R16 is the closest common size, at -0.1% overall diameter (29.0 in against 29.0 in). Most makers treat about 3% as the limit for a swap without speedometer or clearance problems, but always confirm load index, speed rating and wheel width before changing size.

About 696 revolutions per mile (433 per kilometre), from its 29.0-inch rolling diameter. Real-world figures run slightly higher because a loaded tire squats. This number is what your speedometer and odometer are calibrated against.

Last updated: October 2, 2026

Compare any sizes

The full calculator compares up to three sizes with speedometer error, clearance change and a to-scale diagram.

Open the tire size calculator

Other 22-inch sizes

265/40R22 275/40R22 285/40R22 285/45R22 305/40R22 255/30R22 265/35R22 285/35R22 305/45R22