295/55R20 Tire Size in Inches

Diameter, width, sidewall and the closest equivalent sizes, computed from the size code.

295/55R20
32.8" tall × 11.6" wide
On a 20-inch wheel · roughly 32.8x11.6R20 in flotation sizing
MeasurementInchesMillimetres
Overall diameter32.78833
Section width11.61295
Sidewall height6.39162.2
Wheel diameter20508
Circumference103.02615
Revolutions per mile615 (382 per km)

What 295/55R20 means

295 is the section width in millimetres (11.6 in). 55 is the aspect ratio: the sidewall is 55% as tall as the tire is wide, which works out to 162.2 mm or 6.4 in. R20 is a radial tire for a 20-inch wheel.

Overall diameter is the wheel plus two sidewalls: 20 + 2 × 6.39 = 32.8 inches. These are the nominal dimensions every maker builds to; a real 295/55R20 can measure a few tenths of an inch differently by model and inflation.

Closest equivalent sizes

Common sizes within the usual 3% of 295/55R20's overall diameter. Confirm load index, speed rating and rim width before swapping.

SizeDiameterWidthChangeSpeedometer at 60
305/45R22 new wheels 32.8 in 12.0 in +0.1% really 60.1 mph
305/70R16 new wheels 32.8 in 12.0 in +0.1% really 60.1 mph
285/75R16 new wheels 32.8 in 11.2 in +0.2% really 60.1 mph
285/70R17 new wheels 32.7 in 11.2 in -0.2% really 59.9 mph
305/65R17 new wheels 32.6 in 12.0 in -0.5% really 59.7 mph
265/70R18 new wheels 32.6 in 10.4 in -0.5% really 59.7 mph

Speedometer if you switch to 305/45R22

Your speedometer stays calibrated for 295/55R20. With a taller tire you travel faster than it shows.

Speedometer readsTrue speed
30 mph30.0 mph
45 mph45.0 mph
55 mph55.1 mph
65 mph65.1 mph
75 mph75.1 mph
Compare 295/55R20 with any size →

Shop 295/55R20 tires

Check the load index and speed rating on your door-jamb placard before you buy, especially for LT tires used for towing.

See 295/55R20 tires on Amazon →

As an Amazon Associate we earn from qualifying purchases.

Frequently Asked Questions

A 295/55R20 tire is 32.8 inches (833 mm) tall overall. That is the 20-inch wheel plus two sidewalls of 6.4 inches each (55% of the 295 mm section width). Expect a real tire to measure within a few tenths of an inch of this, depending on the model and inflation.

The section width is 295 mm, or 11.6 inches, measured sidewall to sidewall on the recommended rim width. The tread itself is narrower than that. In flotation sizing, 295/55R20 is roughly a 32.8x11.6R20.

305/45R22 is the closest common size, at +0.1% overall diameter (32.8 in against 32.8 in). Most makers treat about 3% as the limit for a swap without speedometer or clearance problems, but always confirm load index, speed rating and wheel width before changing size.

About 615 revolutions per mile (382 per kilometre), from its 32.8-inch rolling diameter. Real-world figures run slightly higher because a loaded tire squats. This number is what your speedometer and odometer are calibrated against.

Last updated: October 2, 2026

Compare any sizes

The full calculator compares up to three sizes with speedometer error, clearance change and a to-scale diagram.

Open the tire size calculator

Other 20-inch sizes

235/35R20 235/45R20 235/55R20 245/35R20 245/40R20 245/45R20 245/50R20 255/35R20 255/40R20 255/45R20 255/50R20 255/55R20 265/40R20 265/45R20 265/50R20 275/35R20 275/40R20 275/45R20 275/50R20 275/55R20 275/60R20 275/65R20 285/45R20 285/50R20 285/55R20 285/60R20 285/65R20 295/35R20 295/45R20 305/55R20 295/60R20 305/50R20 315/35R20